Quality control during construction or renovation is the fastest way to avoid costly rework. If you are accepting work in Fontana, start with a simple inspection routine and a few basic tools: a laser level (or long bubble level), tape measure, 2 m straightedge, square, and flashlight. 1) Begin with documentation. Ask for the scope of work, materials, and any drawings. Compare what was installed to what was agreed, then create a punch list for items that need correction. 2) Check levels and planes. Floors should be even without visible waves. Place a straightedge in several directions and look for gaps; use a laser to confirm consistent elevation across rooms, especially at doorways and transitions. 3) Verify wall plumb and alignment. Use a level to confirm walls are vertical and not “bulging.” Shine a flashlight along the surface to reveal bumps, depressions, or poor drywall finishing. 4) Confirm geometry: corners and dimensions. Measure room diagonals—if they match, the layout is square. Check corners with a framing square; misaligned angles can cause issues with cabinets, tile, and trim. 5) Openings and lines. Doors and windows must be plumb, level, and square. Inspect reveals (gaps around frames) and ensure smooth operation without rubbing. 6) Finishes and detail checks. For tile, look for consistent grout lines and lippage. For paint, confirm uniform coverage and clean cut lines. For trim, check tight joints and straight runs. Finally, do a walkthrough with the contractor, agree on deadlines for fixes, and only sign acceptance when critical items are resolved. This approach protects your budget and ensures renovation results match expectations.
Your email address will not be published. Required fields are marked *
